top of page

ScaffGap Ltd Newsletter

ScaffGap Ltd is very excited upon the launch of their latest addition to their catalogue: 'System-L'.


System-L ScaffGap

Following extensive research, development and design, System-L was designed specifically to work on Layher scaffold platforms. System-L has been designed and manufactured to provide a very robust solution to bridge the inherent 125mm gap and can be used time and time again.

The curved bottom section sits on the ledger below the Layher decks.


Our Latest ScaffGap Product

System-L ScaffGap’s top section provides a flush finish spanning 190mm. The top flat surface has a slightly ridged finish to provide an anti-slip feature.

Pre-drilled holes in the bottom section supporting walls provide a method of securing System-L ScaffGap with zip ties to the ledger below.

During our journey of research and development for this version, a proto-type was made to ensure our calculations and measurements were correct.


System-L ScaffGap trialled on a Layher Scaffold Platform

The versions of ScaffGap are as detailed below;

Tube and Fitting ScaffGap.

Composite Board ScaffGap.

System-C ScaffGap (For use on Cuplok Platforms where traditional

scaffold boards are used).

System-L ScaffGap (For use on Layher scaffold platforms).

Unit Transom Platforms.


Tube and Fitting ScaffGap


Tube and Fitting ScaffGap is specifically designed to bridge the inherent 50mm gap created by the inside supporting standards of a scaffold. It simply clips to the underside of a board and butts a parallel board, providing a gap free surface. The 38mm depth bottom section secures ScaffGap into place. The flush top section spans 116mm.


Tube and Fitting ScaffGap

Composite Board ScaffGap


The Composite Board version of ScaffGap is the same as the Tube and Fitting version except the depth of the bottom section increases from 38mm to 45mm due to the increased depth dimension of the Composite Board.


Composite Board ScaffGap

System-C ScaffGap


System-C ScaffGap was specifically designed to be used on Cuplok Scaffolding platforms where traditional scaffold boards are used. The inherent gap in the Cuplok platform is considerably greater than that of Tube and Fitting platforms, increasing from 50mm to 95mm. The Cuplok version top section spans 155mm, adequately eliminating gaps.


System-C ScaffGap


The lengths of the system type ScaffGap are pre-cut to order as to the designated bay sizes. Where traditional Tube and Fitting is used ScaffGap is pre-cut as per the order, determined by heavy duty, general purpose and light duty bay sizes.

ScaffGap can be easily cut using a wood saw if required.

All versions of ScaffGap are totally reusable and recyclable offering a great return on investment.


ScaffGap is manufactured in the UK.


For more information about our products contact ScaffGap Ltd on our website at www.scaffgap.co.uk or


  • John Houlihan ( Director ) 07930 606665

  • Steve Barlow ( Director ) 07825 332334



ScaffGap Limited is a registered company in England.

Registration No. 6962375.

Commentaires


bottom of page